Pharmaceutical Chemicals: Management

 MANAGEMENT

Various Official Compendia of different countries categorically specify descriptive as well as informa-tive details with regard to the pharmaceutical substances and formulated dosage forms produced therefrom. Hence, all pharmaceutical chemicals and finished products must rigidly conform to the laid-out standards in a particular country and are subjected to various checks at different levels either by Government/State owned drug testing laboratories or by Government/State approved drug testing laboratories.

 

Official Compendia for pharmaceutical substances usually include the following parameters, namely :

 

·              Description of the Drug or Finished Product

 

·              Identification Tests

 

·              Physical Constants

 

·              Assay of Pharmaceutical Substances

 

·              Assay of Principal Active Ingredients in Formulated Dosage Forms

 

·              Limit Test

 

·              Storage Conditions

Comments

Post a Comment

Popular posts from this blog

Karl Fischer Method for Determination of Water

Image
  INTRODUCTION A plethora of chemical compounds for the determination of small amounts of water present in organic solids, pharmaceutical substances and organic solvents have been devised over a length of time. But unquestionably the most important of these is the one proposed by Karl Fischer (1935), which is considered to be relatively specific for water*. It essentially makes use of the Karl Fischer reagent which is composed of iodine, sulphur dioxide, pyridine and methanol.   Note : Both pyridine and methanol should be anhydrous.   THEORY Water present in the analyte reacts with the Karl Fischer reagent in a two-stage process as shown below : From Eq. ( a ) step l, it is obvious that the oxidation of sulphur dioxide takes place by iodine to yield sulphur trioxide and hydrogen iodide thereby consuming one mole of water. In other words, each one molecule of iodine disappears against each molecule of water present in the given sample. It is pertinent to mention here that ...
Read more

Volumetric Analysis

Image
  VOLUMETRIC ANALYSIS Volumetric analysis may be broadly defined as those analytical methods whereby the exact volume of a solution of known concentration actually consumed during the course of an analysis is considered as a measure of the amount of active constituent in a given sample under determination (assay).   1. THEORY   According to the  official method of analysis , hydrochloric acid can be determined by  first  weighing a given sample accurately, and  secondly , by adding carefully a solution of known strength of sodium hydroxide in the presence of an appropriate indicator unless and until the exact equivalent amounts of HCl and NaOH have undergone the following chemical reaction : Analyte (or Active Constituent)  is the chemical entity under assay   e.g. , HCl.   Titrant  is the solution of known strength (or concentration) employed in the assay   e.g. , NaOH.   Titration  is the process of adding and then ...
Read more

Thermoanalytical Analysis

  INTRODUCTION Thermoanalytical methods  essentially encompass such techniques that are based entirely on the con-cept of heating a sample followed by well-defned modified procedures, such as : gravimetric analysis, differ-ential analysis and titrimetric analysis. In usual practice, data are generated as a result of continuously re-corded curves that may be considered as ‘thermal spectra’. These thermal spectra also termed as  ‘thermograms , often characterize a single or multicomponent system in terms of :   ( a ) temperature dependencies of its thermodynamic properties, and   ( b ) physicochemical reaction kinetics.   Broadly speaking the thermoanalytical methods are normally classified into the following three categories, namely :   ( i ) Thermogravimetric Analysis (TGA),   ( ii ) Differential Thermal Analysis (DTA), and   ( iii ) Thermometric Titrations.   All the above mentioned techniques shall be discussed briefly with specific re...
Read more