Thin Layer Chromatography (TLC): Theory

 THEORY

The adsorbent used in TLC is a thin, uniform layer (normally 0.24 mm thick) of a dry, finely powered material applied to an appropriate support, such as a glass plate or an aluminium sheet or a plastic foil. Subsequently, the mobile phase is permitted to move across the surface of the plate (usually by capillary action) and the chromatographic phenomenon may solely depend upon adsorption, partition, or a combination of both, depending on the adsorbent, its treatment, and the nature of the solvents employed. During the chromatographic separation procedure the TLC-plate is placed in a chromatographic chamber, mostly made up of glass to enable clear observation of the movement of the mobile phase up the plate, that is pre-saturated with the solvent vapour. The inert solid supports invariably employed are, namely : alumina, silica gel, kieselguhr and cellulose, to these may be added appropriate substances, for instance : calcium sulphate (gypsum) so as to provide adequate adhesion to the solid support, example : silica gel-G (G-stands for gypsum).

 

The prepared layer may be impregnated with suitable materials to achieve specific purpose, namely :

 

(i) Buffering materials : To afford acidic, basic or neutral layers,

 

(ii) Silver nitrate : To modify its characteristics e.g., for separation of methyl esters of fatty acids, and

 

(iii) Ion-exchange materials : To modify its properties, e.g., admixture of cellulose with ion-exchange resins used for the separation of nucleic acids and their respective derivatives.

 

Therefore, the application of skill and wisdom may give rise to a fairly wide spectrum of possible layers, employed in conjunction with a vast combination of solvent systems permits and affords an almost infinite variation of separating power that really makes TLC such a versatile and useful technique in the domain of pharmaceutical analysis.

 

1. VERSATILITY OF TLC OVER PAPER AND COLUMN CHROMATOGRAPHY

 

In general, TLC essentially not only amalgamates the meritorious plus points of both paper and column chromatography but also it is distinctly superior and more versatile to either of the two methods. However, the versatility of TLC over paper and column chromatography are quite evident from the following points, namely :

 

(i) Simple equipments : TLC mostly requires very simple equipments, such as : micro-slides ; specimen jars with lid ; glass-sprayers ; strips of glass sheet ; small chromatank etc.

 

(ii) Short development time : In TLC, the separation is very rapid i.e., the development time is of short duration (say 1 hour) for reasonably good separation on inorganic adsorbent layers. Hence, it has a positive edge over paper and column chromatography which normally takes several hours or days.

 

(iii) Wide choice of stationary phase : TLC may be used for adsorption, partition (including reversed phase) or ion-exchange chromatography,

 

(iv) Quick recovery of separated constituents : TLC permits the possibility of removal of the adsorbent coating on the plates by scraping with a spatula. In other words, a spot or a zone can be removed quantitatively, and the separated constituent dissolved in an appropriate solvent is estimated either by suitable spectrophotometric or colorimetric analysis.

 

(v) Separation effects : The separation effects obtained by TLC are more distinctive and superior than those of paper chromatography,

 

(vi) Easy visualization of separated components : Detection of fluorescence components when exposed to UV light is much easier than on paper by virture of the fact that inorganic material (i.e., adsorbent) has intrinsic fluorescence,

 

(vii) Detection Limit : TLC affords extremely sharp delineated spots and offer lower detection limit i.e., one decimal power less than that in paper chromatography,

 

(viii) Variable thickness of think layers : The method employed in TLC may be further extended to preparative separations by using thicker layers and also to meet separations by column chromatog-raphy,

 

(ix) Chemically inert stationary phase : Use of inorganic adsorbents e.g., alumina and silica, in TLC allows the application of corrosive sprays to detect fractionated substances, for instance : carbohy-drates by 70% conc. H2SO4, and

 

(x) Trace analysis : TLC method is suitable as micromethod in trace analysis.

Comments

Post a Comment

Popular posts from this blog

Karl Fischer Method for Determination of Water

Image
  INTRODUCTION A plethora of chemical compounds for the determination of small amounts of water present in organic solids, pharmaceutical substances and organic solvents have been devised over a length of time. But unquestionably the most important of these is the one proposed by Karl Fischer (1935), which is considered to be relatively specific for water*. It essentially makes use of the Karl Fischer reagent which is composed of iodine, sulphur dioxide, pyridine and methanol.   Note : Both pyridine and methanol should be anhydrous.   THEORY Water present in the analyte reacts with the Karl Fischer reagent in a two-stage process as shown below : From Eq. ( a ) step l, it is obvious that the oxidation of sulphur dioxide takes place by iodine to yield sulphur trioxide and hydrogen iodide thereby consuming one mole of water. In other words, each one molecule of iodine disappears against each molecule of water present in the given sample. It is pertinent to mention here that in the presenc
Read more

Volumetric Analysis

Image
  VOLUMETRIC ANALYSIS Volumetric analysis may be broadly defined as those analytical methods whereby the exact volume of a solution of known concentration actually consumed during the course of an analysis is considered as a measure of the amount of active constituent in a given sample under determination (assay).   1. THEORY   According to the  official method of analysis , hydrochloric acid can be determined by  first  weighing a given sample accurately, and  secondly , by adding carefully a solution of known strength of sodium hydroxide in the presence of an appropriate indicator unless and until the exact equivalent amounts of HCl and NaOH have undergone the following chemical reaction : Analyte (or Active Constituent)  is the chemical entity under assay   e.g. , HCl.   Titrant  is the solution of known strength (or concentration) employed in the assay   e.g. , NaOH.   Titration  is the process of adding and then actually measuring the volume of titrant consumed in the   assay. Thi
Read more

Thermoanalytical Analysis

  INTRODUCTION Thermoanalytical methods  essentially encompass such techniques that are based entirely on the con-cept of heating a sample followed by well-defned modified procedures, such as : gravimetric analysis, differ-ential analysis and titrimetric analysis. In usual practice, data are generated as a result of continuously re-corded curves that may be considered as ‘thermal spectra’. These thermal spectra also termed as  ‘thermograms , often characterize a single or multicomponent system in terms of :   ( a ) temperature dependencies of its thermodynamic properties, and   ( b ) physicochemical reaction kinetics.   Broadly speaking the thermoanalytical methods are normally classified into the following three categories, namely :   ( i ) Thermogravimetric Analysis (TGA),   ( ii ) Differential Thermal Analysis (DTA), and   ( iii ) Thermometric Titrations.   All the above mentioned techniques shall be discussed briefly with specific reference to their theory, instrumentation, methodo
Read more